15
FRONTAL PANEL CONTROL
9.1 Manual-Switching
When the switcher is in the manual switching mode, press the
SELECT AUTO/3s
button
repeatedly to cycle through the four video inputs, and the corresponding source LED
illuminates green immediately.
9.2 Auto-Switching
Press and hold the
SELECT AUTO/3s
button at least three seconds to enable auto-
switching, and the AUTO LED turns green.
When in the AUTO mode, the switcher will switch according to the following rules:
•
The switcher will switch to the first active input starting from VEOCast to PC3.
•
New input: The switcher will automatically select the new input once detecting a
new input.
•
Reboot: If power is restored to the switcher, it will automatically reconnect the input
before shutdown.
•
Source removed: When an active source is removed, the switcher will switch to the
first active input starting from VEOCast input to PC3.
•
In auto mode, the input source also can be switched by the manual switching steps.
•
Press and hold the SELECT AUTO/3s button at least three seconds again can exit
AUTO mode, but the input source will not be changed.
Note that the VEOCast is not an active input when there is no screen sharing device
connection.
9.3 Display Control
⚫
Manual Control:
Press the
DISPLAY ON
/
OFF
buttons on the front panel to
simultaneously send RS232 and CEC commands to turn on/off the display device.
⚫
Auto Control:
When detecting a video input signal (5V or TMDS), automatically
send CEC and RS232 commands to turn on the display device. When not detecting
any video signal within the setting time (default 10mins), automatically send RS232
and CEC commands to turn off the display device.
The RS232 command can be customized by sending commands, please refer to the
chapter
for more details.
