12
3.The engine will now stop.
IMPORTANT!
Running in the engine
During the first ten hours of work, run the engine at a moderate RPM and not
at full throttle.
Allow 10 hours of use to run in the engine.
It is at the end of the run-in period that the engine will reach its maximum
power.
After the first two hours of work, stop and make sure that all nuts and
screws are securely fastened, and tighten them if necessary.
Storage and Maintenance
·When you finish working, clean completely, making sure there is no grass or
dirt wrapped in the cutting teeth, wipe with a slightly oily rag and replace blade
covers.
·Store away from direct sunlight and out of the reach of children.
·Do not store in a nylon bag as this can encourage the formation of mould.
·At the end of the season, give the equipment an overall cleaning and a
thorough check.
Air Filter
Accumulated dust in the air filter will reduce engine
efficiency increase fuel consumption and allow abrasive
particles to pass into the engine. Remove the air filter as
often as necessary to maintain a clean condition.
Remove filter cover by unscrew the bolt.
Light surface dust can readily be removed by tapping the
filter.
Heavy deposits should be washed out in warm soapy water.
Fuel Filter:
·The fuel tank is fitted with a filter.
·The filter is situated at the free end of fuel pipe and can be
picked out through fuel port with a piece of hooked wire or
Summary of Contents for EKPWT1
Page 16: ...16 Exploded View and Parts List ...
Page 17: ...17 ...
