- 6 -
i)
Before you start working remove any debris from the ground to avoid tripping.
j)
Always stand in a secure position and keep your balance.
k) Always keep extension and connecting cables behind the saw or away from the cutting area.
l)
Only use spare parts approved by the manufacturer, in particular with regard to the chain and
chain guide.
m) We highly recommend the use of an RCD (residual current detector) at all times. These are
inexpensive and available from all good hardware outlets.
n
）
.When cutting a branch under tension, understand that the branch will bounce back so keep well out of
the way.
o
）
Kickback causes and prevention:
Kickback may take place when the saw bar point touches an item or when the wood bends and the saw chai
n gets stuck in the cutting.
In many cases, a contact with the bar point may lead to a situation when the operator unexpectedly bends b
ackward and as a result, the bar is ejected upward toward the operator .
Backlash is a result of inappropriate or wrong use can be prevented by appropriate preventive measures des
cribed below:Hold the saw firmly with both hands with thumbs and fingers embracing the chainsaw handles.
Avoid abnormal body posture and do not cut above the shoulder level. This will prevent a contact with the
bar point .
Safety instructions for grass trimmers and brush cutter:
Proper and safe use
a)
Wear eye protection and gloves.
b)
Never allow children or people who are not familiar with the
se
instructions to use the machine.
c)
Stop using the machine when people, in particular children or pets, are nearby. A minimum 15m
distance is recommended.
d)
Only use the machine in daylight or bright artificial lighting.
e)
Before starting to operate the machine and after any impact check for signs of wear and tear or
damages and have the necessary repairs carried out. Never use the machine when the
protection is damaged or missing.
f)
Always keep hands and feet away from the cutting unit, especially when you switch on the
engine.
g)
Treat the cutter that is used to cut the length of trimming line with care
– you could injure yourself
with it. After you’ve pulled out a new thread always keep the machine in its normal working
position before switching it on.
h)
Never use anything other than the correct nylon cutting line.
i)
Never use spare parts and accessories not provided or recommended by the manufacturer.
j) Make sure that any ventilation holes are free from dirt. If required, use a vacuum to clear
obstructions.
WARNING!
This power tool produces an electromagnetic field during operation. This field may under
some circumstances interfere with active or passive medical implants. To reduce the risk of serious
or fatal injury, we recommend persons with medical implants to consult their physician and the
Summary of Contents for EKEMS2
Page 21: ... 20 ...
