- 11 -
The handle has two parts. First seperate the upper and lower parts by removing the four hex-bolts
using the hex key supplied.
The power unit handle has two black rubberized cover sections. The longer one is sponge rubber,
the shorter one is strong rubber. The longer which has a soft feel is firmly fixed and for hand grip use
only.
Do not
attempt to mount “D” handle on this section.
While the shorter is moveable on which “D”handle needs to mounted. Make sure there is no
movement when mounting “D”handle. (Photo 1)
2)
Fitting the attachments(including 100cm extra extension pole) to the power unit:
Please note, check the inside of aluminium connectors and the inside/outside if the connecting
poles for any dirt, grit or aluminium swarf that may obstruct smooth connection .Brand new
connectors and tubes may be a little tight to begin with. Please wipe clean with a rag and then rub a
little oil or vaseline inside the connectors to ensure easy fitting and disconnection.
Press the lock button (Photo 2).
Align the hole in the pole with the hole in the connector of power
unit . Push in the tube (either a tube already fitted to one of the attachments or the optional extra
extension tube) until you see and hear a click from the connector (see photo 3).Tighten the knob.
To disconnect:
Loosen the knob on the connector, push down the pole in the connector and at the same time press
the lock button
.
Pull out the attachment.
3) Fitting the belt :
Photo 4
Lock button
Photo 1
Photo 2
Photo 3
Summary of Contents for EKEMS2
Page 21: ... 20 ...
