ECKELMANN UA 410 D, Operating Instruction

Page: 69 / 142

Pin and Terminal Assignments of UA 410 D
61 Firmware V1.40 - Doku 2.1 06. April 2016
6.7 Terminal assignment of the CAN bus
Warning - hazardous electrical voltage!
If mains voltage is connected to the CAN bus terminals,
this will result in the destruction of all components connected to the CAN bus!
Leads running of the CAN bus must be shielded (cable type: LiYCY)! As a general rule, care should
be taken to ensure that signal leads and leads carrying a supply voltage are routed through separate
cable channels.
OFF
1 2 3 4 5 6 7 8
BATTER Y
DI P S W ITC H
S 3
ON
1 2 3 4 5 6 7 8
ZNG:112 930 DEF4
CAN-HIGH
CAN-LOW
CAN-GND
CAN-BUS
weiß / white / blanc
braun / brown / brun
grün / green / vert
SHLD
LiYCY 2 x 2 x 0,75 mm²
10 1
D32 D31 D22 D21 D12 D11
73 74 43 44 63 64 53 54
2 1 3 4
CAN-GND
CAN-LOW CAN-HIGH
SHIELD
31 32 30 29
D42 D41
GND
AO2
GND
AO1
5
0
2
3
1
4 6
7
8
9
5
0
2
3
1
4 6
7
8
9
CAN-BUS
ADDRESS
1..99
CAN-BUS- L ED
For further details on the setting of the CAN bus address see chapter 5.3.
Controller
Type Terminal No. CAN bus Lead colour
Alle controllers 1 Shielding (SHLD) Shielding
2 CAN-GND green
3 CAN-LOW brown
4 CAN-HIGH white
The orange CAN bus LED always flashes when data are being exchanged via the CAN bus with the
system centre / store computer; see chapter 5.5.1 Status LEDs for details.