Firmware V2.0L - Doku-Version V1.9 - Current to March 2021
6
3 Installation and Commissioning of the CAN Bus Repeater
3.1 Installation and connection to the CAN bus
Before commissioning, the CAN bus repeater
must
first be connected to the first CAN bus segment via the
front COMBICON plug. The second CAN Bus segment is then connected to the top connections of the CAN
bus repeater. Finally, the device is supplied with 24 V DC power (power pack, order number KGLNT24V1P):
Example:
Picture 3.1:
Connection of the CAN bus-repeater
Note
: The determination „First
CAN bus segment
“ bzw. „Second
CAN bus segment
“ is scalable.
* The start and end of a CAN Bus segment
must
each be connected to a terminating
resistor
R=100 Ohm
(0.25 W)!
Tip: Use connector set with terminating resistor to terminate the CAN bus,
order No. KGLCANTERM.
