ECI 1000-U LCD Installation Manual
Electronic Controls, Inc.
7073 North Atlantic Ave. Cape Canaveral, FL 32920
800-633-9788
P a g e
|
11
6.3.5.2
Parameter settings and defaults
CF
– Close Fast Speed – Default setting is 60. Range is 1-100
CS
– Close Slow Speed – Default setting is 20. Range is 1-100
SS –
Close slow start – Default setting is 20. Range 1-100.
CFH
– Close Fast Heavy Door Speed – default is 20. Range is 1-100
PL
– Open slow Start speed – Default is 20. Range is 1-100
OS
– Open Slow speed – Default is 20. Range is 1-100.
OF
– Open Fast speed – Default is 60. Range is 1-100.
N
– Nudging speed – Default is 10. Range is 1-100
CCL
– Closing Force – Default is 30. Range is 1-100
DLF
– Door Locking Force – Default is 10. Range is 1-100
DEC
– Deceleration Rate – Default is 10. Range is 1-100.
ACC
– Acceleration Rate – Default is 10. Range is 1-100
FDEC
– Reversal Deceleration Rate – Default is 10. Range is 1-100.
Motor Direct
– Used for swapping open/close direction. 1 is forward 2 is reverse
Input voltage –
Default is 110. Range is 24 – 320.
6.3.6
Load Defaults menu
Selecting Load Defaults sets all parameters to their default settings. Refer to section 6.3.5.2 for default
settings.
6.3.7
Diagnostic Menu
Figure 3 - Diagnostic Menu
VBUS
– Displays the current voltage of the 54P input
DRIVE
– The drive to the motor is pulse width modulate. This number reflects the percentage of
drive to the motor. 0% will be no power to the motor and 100% will be max drive.
16s
– This is the present count of the 16 second stall timer. Should an open or close cycle time
out the door board will stall the motor until the open/close command is cycled off/on.
TEMP
– Displays the current temp in °C/°F of the output driver transistors.
MOTOR
– Displays the current amperage to the motor.
SPEED
– Displays the current speed of the open or close cycle.
CYCLE
– Displays the number of cycles the door board has performed since manufacture. One
cycle is an open and close.
ECI Model 1000N
(C) 2015 ECI, Inc.
VBUS : xx.xV
DRIVE: xx% 16s
TEMP : xxC/xxxF
MOTOR: x.xA
Cycle: xxxxx (ESC)
