46
Chapter 5
•
Adjusting antenna azimuth and elevation
1039740-0001 Revision B
Checking the azimuth base starting position
Before making any azimuth adjustments, ensure that the azimuth lockdown bolts
are centered in the curved slots in the azimuth base. See
If the bolts are not centered in the slots:
1.
From underneath the azimuth base, ensure that the four
5
16
⁄
inch azimuth
lockdown nuts are loose.
2.
Use a
1
2
⁄
inch wrench to turn the fine azimuth adjustment bolt until the
lockdown bolts are centered in the curved slots.
You should not have to turn the two inner nuts on the adjustment bolt, but if
they are loose, tighten them.
Leave the lockdown nuts loose so you can adjust azimuth.
Figure 26: Checking the azimuth base starting position
One of the azimuth
lockdown nuts is
attached to this
barrel
Azimuth base
1 of 4 azimuth
lockdown bolts
Azimuth base
Azimuth
adjustment
bolt
View from underneath azimuth base
Loosen 4 azimuth lockdown nuts (arrows) from
underneath the azimuth base.
Note:
The fourth lockdown nut is not visible in this view.
Top View