Installation
Section 3
Digital Satellite Receiver
Page 3 - 3
©
2
001
E
c
hoS
tar
Inte
rnati
o
nal
C
o
rp
orat
io
n
A
ll
ri
g
hts
re
s
erved
3
M
OTORIZED DISH INSTALLATION WITH
LNB(F)
1. On the dish installation (for detailed instructions refer to the manufacturer’s instructions):
a.
connect a RF coaxial cable;
b.
connect the power and sensor cables;
c.
if present, set the East and West limit switches to prevent dish damage.
2. On the rear panel of the receiver find:
a.
the
LNB IN
connector;
b.
the
M.PULSE
, the
GND
, the
M1
and the
M2
connectors.
3. Install the F-connector (dish) to the
LNB IN
connector (receiver).
4. On the rear panel of the receiver find the
M.PULSE
, the
GND
, the
M1
and
M2
connectors.
5. First install the motor sensor cables to the
M.PULSE
and
GND
connector (receiver).
6. Install the motor power cable to the
M1
and
M2
connectors (receiver).
D
ISH INSTALLATION WITH
F
ERRITE FEED
1. On the dish installation, connect the ferrite cables (for detailed instructions refer to the
manufacturer’s instructions).
2. On the rear panel of the receiver find the
F
and the
Ferrite -
connectors.
3. Install the ferrite power cable to the
F
and
Ferrite -
connectors (receiver).
D
ISH INSTALLATION WITH
P
OLAROTOR
1. On the dish installation, connect the polarotor cables (for detailed instructions refer to the
manufacturer’s instructions).
2. On the rear panel of the receiver find the
+ 5V
, the
GND
and the
SKEW
connectors.
3. Install the polarotor power cable to the
+ 5V
and
GND
connectors (receiver).
4. Install the polarotor skew cable to the
SKEW
connector (receiver).
CAUTION
It is possible that the
GND
connector is already occupied by the motor sensor
cable. If you need to connect the GND for the polarotor as well, please use the
appropriate connection materials to connect both cables. Failing to do so can
cause damage to the equipment.
