4
Installation Guide
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - [email protected] (US)
email - [email protected] (Europe)
Wiring Diagrams
SSM-RBP / SSM-DIS
Parking Sensor System
with Buzzer or Display
SSM-RBP
Red -
Connect to a +12V switched ignition supply.
Black -
Connect to ground.
Yellow -
Connect to +12V switched reverse wire.
Blue -
Not connected.
White -
Not connected.
Grey -
Only used when combining 2 kits into
a complete front and rear installation - joining both
modules together.
2 Pin Plug -
Connect to the supplied buzzer.
SSM-DIS
Red -
Connect to a +12V switched ignition
supply.
Black -
Connect to ground.
Yellow –
Only used in rear mode - Connect to
+12V switched reverse wire.
Blue –
Not connected in rear mode. In front
mode, connect to the supplied switch and
connect the other side of the switch to +12V IGN.
White –
Not connected in rear mode. In front
mode, connect this wire to the vehicle analog
speed pulse wire (this can often be found behind
the radio or the instrument cluster).
Grey –
Only used when combining 2 kits into a
complete front and rear installation - joining both
modules together.
2 Pin Plug –
Not used in rear mode. In front
mode, the black wire of this plug can be used to
trigger a camera or other device to automatically
turn on below the set speed (+12V output).
PLEASE NOTE
The sensors are labelled A, B, C and D for both
modules. Please ensure that these are plugged into
the corresponding ports on the module.
Please reference the following wiring diagrams & information for various
installation
