12
Using Smart Click to Configure the ERDRC
Configuring the ERDRC controller requires that at least one wireless PTM wall
switch is linked to the controller.
The Smart Click menu includes these parameters:
Level 1
Learn Mode
Level 2
Clear Switch/Clear All
Level 3
Repeater Function
Level 4
Status Telegram Function
Level 5
Time out Periods
Level 6
Auto-ON with Motion Function
Level 7
Dimming Output Function
Level 8
Light-ON-Setpoint
Level 9
Maximum Dimming Output
Level 10
Minimum Dimming Output
Linking the First Switch
• With the ERDRC controller in the factory default state, click the PTM switch
ON three times, OFF three times and ON three times quickly.
Using this method of linking a switch will only work on the first PTM switch. Use
Smart Click to link additional switches or to configure the controller parameters.
Entering Smart Click Configuration Mode
It is important to have feedback (light) from the ERDRC controller during
configuration.
• Using a linked switch (see above), turn the light OFF.
• Click and hold the switch OFF for 10 seconds. The light will blink once and
then turn on. If the switch is linked to more than 1 ERDRC controller you
will have to click the ON side of the switch until the controller you wish to
configure is selected indicated by the light turning ON.
• Press ON for 5 seconds. The light will begin blinking once.
Linking an additional switch or sensor
• Enter Smart Click configuration mode and with the light blinking once,
press ON for 3 seconds. The light will begin blinking ON/OFF every second.
• Add additional PTM switches by clicking ON 3 times quickly. Add sensors by
pressing the TEACH button on the sensor.
• To continue with configuration, press the switch ON for 3 seconds, the light
will resume blinking once. To exit Smart Click press OFF for 5 seconds.
