Page 7
ELEDR(H) Installation Guide
LED Blink Codes and Operation
The tables below describe the LED activity and associated mode of the
controller.
If the controller was factory pre-commissioned, upon power up it will
immediately begin blinking the POWER LED based on the type and count of
linked devices.
The type is indicated by long blinks followed by short blinks counting the
number of devices linked. This pattern will repeat after a short pause
See the ELEDR programming guide for more information:
https://www.echoflexsolutions.com/files/8DC-5997-ELEDR-Programming-Guide.pdf
The table below describes the number of LED blinks for each device type.
RED POWER LED Blink Codes
Factory Default
ON Solid
switch(es)
1 long blink
followed by short blinks counting switches
occupancy sensor(s)
2 long blinks
followed by short blinks counting sensors
photo sensor(s)
3 long blinks
followed by 1 short blink counting a sensor
central command
4 long blinks
followed by short blinks counting devices
demand response
5 long blinks
followed by short blinks counting devices
Operating Mode and LED Activity
Mode
LEARN LED : Red POWER LED: Red
Relay/Light
link mode
ON
toggle
toggle
storing ID
ON
ON 4 seconds
ON 4 seconds
clearing ID
ON
OFF 4 seconds
OFF 4 seconds
factory default Off
(flash on power up)
ON solid
ON
