Echoflex Installation Guide
Tunable White Dimming Controller
Tunable White Dimming Controller
Page 3 of 8
Echoflex
Installation
All local codes and standard electrical practices should be observed. Ensure
that the junction box is clean and free of obstructions and that all wiring is
installed correctly.
Install the Controller
Mount the controller directly to the exterior of the junction box or panel
either at the electrical load or before the load in the circuit.
Review these instructions completely before installing the controller.
1. Locate the circuit breaker panel and terminate power to the circuit.
2. Remove the cover plate and other hardware from the junction box to
access the wiring.
3. Mount the controller.
4. Refer to the wiring diagram to connect the controller to line power,
neutral, and load wires. Use wire nuts on all connections and
individually cap any bare wires, except the orange antenna wire.
5. Connect the gray and the striped violet/red wires to the driver or
ballast’s dimming interface. Connect the striped violet/green 0-10 V
analog color control output wire to the tunable white input on the LED
driver.
6. Replace the electrical box cover plate.
7. Restore power to the circuit.
Note:
Follow applicable NEC and local electrical code
requirements when installing and powering the
controller.
Note:
The Micro USB port is for factory use only. Do not attach
cables or accessories to this port.
