Echo SRM series, Safety Manual

Page: 15 / 52

ENGLISH
SRM MODELS:
If your trimmer-brushcutter requires assembly before it
can be used, you must make sure the unit is properly
configured for the type of cutting attachment you will be
using. Follow the instructions in the Operator’s Manual
provided with the unit. You must install the required
cutting attachment, debris shield, handle, and any other
protective devices needed, such as a harness loop and
safety harness. See SRM/PAS/SB Set-Up Guide Page 17)
If your trimmer-brushcutter has been preassembled, you
must make sure the unit is properly configured for the type
of cutting you will be performing. If the unit is not properly
configured, you must first remove the incorrect parts, and
then install the correct parts, following the instructions
in the Operator’s Manual before using the trimmer-
brushcutter,
PAS/SB MODELS:
Pro Attachment Series (PAS) and Split-Boom (SB) models
are for use only with PAS series attachments, and must
not be used with any other type or brand of attachment.
Select the desired PAS attachment, and assemble
the attachment to the powerhead driveshaft using the
coupler. Follow the safety and operating instructions in
the Operator’s Manual provided with the attachment, and
General Safety Instructions in this Safety Manual.
SRM MODEL
Front
Handle
Front
Handle
Debris
Shield
PAS MODEL
The Pro Attachment Series and Split-Boom models allow the use of a wide
range of attachments to perform various lawn, garden, and landscaping tasks.
These attachments have individual safety and operating rules which must
be obeyed for safe operation. You must read and understand the safety and
operating instructions for each attachment before using the unit. You must also
review the general safety instructions for PAS Attachments.
If you change PAS attachments, you must also make sure your front handle is
properly configured for the new attachment.
PAS/SB Front Handle Configuration
The required front handle configuration of your
PAS/SB unit may change, depending on the
type of PAS attachment being used:
• Use the barrier bar provided with the PAS
power head when instructed in the PAS
Attachment Operator’s Manual.
• Remove the barrier bar when using an
attachment that does not require a barrier.
See the PAS/SB Attachments Barrier Bar Use table for barrier bar usage
information.
15
ASSEMBLY