FH235
ASSEMBLY
X7507820100
13
© 7/2014 ECHO Inc.
ASSEMBLY
Gear Housing Assembly / Drive Shaft
Note: Hedge Trimmer Blades are very sharp. Wear gloves to
protect hands.
1. Remove locating bolt (A) and loosen clamping bolt (B).
2. Remove vinyl cap from drive shaft.
3. Slide Gear Housing Assembly onto Drive Shaft. Be certain
the Flex Drive Shaft engages the hole in Driver Gear.
Flat edge of washer (C) must be against drive shaft.
4. Align locating hole in gear housing with locator hole in drive shaft.
5. Install locating bolt (A). Tighten clamping bolt (B).
OPERATION
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects
away from all openings. Always stop engine, disconnect spark plug, and make sure all moving parts
have come to a complete stop before removing obstructions, clearing debris, or servicing unit.
Operation of this equipment may create sparks that can start fires. This unit is equipped with a spark
arrestor to prevent discharge of hot particles from the engine. Metal cutters can can create sparks if
the cutter strikes rocks, metal, or other hard objects. Contact local fire authorities for laws or
regulations regarding fire prevention requirements.
Fuel
Alternative fuels, such as E15 (15% ethanol), E-85 (85% ethanol) or any fuels not meeting Shindaiwa
requirements are NOT approved for use in Shindaiwa gasoline engines. Use of alternative fuels may
cause performance problems, loss of power, overheating, fuel vapor lock, and unintended machine
operation, including, but not limited to, improper clutch engagement. Alternative fuels may also
cause premature deterioration of fuel lines, gaskets, carburetors and other engine components.
A
B
C
