Echo SC-2013, Operator'S Manual

Page: 11 / 34

6 3 INCH CHIPPER/SHREDDER
Section
2 ASSEMBLY
2.1 ASSEMBLY
2.1.1 INSTALL LEG STAND, AXLE AND
WHEELS
1. Align holes in chipper base (1) with the holes in
axle weldment (2) and the support leg (3). Secure
assembly to chipper base with two 5/16-18 × 2-1/4"
KH[KHDGEROWVDQGÀDQJHQXWV
2. Secure support leg to the base of the housing body
(5) with two 5/16-18 × 1-3/4" hex head bolts (6), and
ÀDQJHQXWV
3. Complete by bolting wheels (7) to axle weldment
using two 5/8" × 3" hex head bolts (8).
4. The axle bolts turn into centerlock nuts in the ends of
the axle bar and consequently turn fairly hard. Care
must be taken not to over tighten the bolts or bearing
damage will occur. A properly tightened bolt will allow
minimal side to side movement of the wheel while
allowing the wheel to spin freely.
2.1.2 ATTACH CHIPPER CHUTE HANDLE
Attach handle (9) to chipper chute (10) using two 5/16" ×
3/4" carriage bolts (11) so the head of the bolt is located
on the inside of the chute. Install both bolts through handle
EHIRUHIDVWHQLQJZLWKÀDQJHQXWV7KLVKDQGOHLVWR
be attached only to the bottom of part 10.
2.1.3 ATTACH SHREDDER HOPPER HANDLE
To attach handle (12) to shredder hopper (13), install four
5/16" × 1" hex bolts (14) so the head of the bolt is located
RQWKHLQVLGHRIWKHKRSSHU6HFXUHEROWVZLWKÀDQJH
nuts.
2.1.4 ATTACH SHREDDER HOPPER
1. Install the shredder hopper (13) to the housing body
so the handle is located above the engine and the
opening is toward the chipper chute.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
If any bolts or nuts are dropped in the machine, be
sure to remove them before starting the machine.
Remove items from the shredder area by removing the
discharge screen.
WARNING
Do not tip machine onto its side or turn machine upside
down during assembly. Machine must be assembled in
an upright position.
WARNING
2. Install eight 5/16-18 × 3/4" carriage bolts (15) so the
head of the bolt is located on the inside of the hopper.
)DVWHQEROWVZLWKÀDQJHQXWV