![background image](http://html1.mh-extra.com/html/echo/ppt-2620h/ppt-2620h_operators-manual_4063932041.webp)
PPT-2620 / H
MAINTENANCE
X7502346700
41
© 11/23 ECHO Incorporated
Carburetor Adjustment
Level 2.
When carburetor adjustment is completed, the cutting
attachment should not move at idle, otherwise serious personal
injury may result.
Engine Break-In
New engines must be operated a minimum duration of two tanks of fuel
break-in before carburetor adjustments can be made. During the break-in
period your engine performance will increase and exhaust emissions will
stabilize. Idle speed can be adjusted as required.
High Altitude Operation
This engine has been factory adjusted to maintain satisfactory starting and
durability performance up to 330 m (1,100 ft.) above sea level (ASL). To
maintain proper engine operation above 330 m (1,100 ft.) ASL the
carburetor may need to be adjusted by an authorized service dealer.
If the engine is adjusted for operation above 330 m (1,100 ft.) ASL,
the carburetor must be re-adjusted when operating the engine below
330 m (1,100 ft.) ASL, otherwise severe engine damage may result.
Note: Every unit is run at the factory and the carburetor is set in
compliance with emission regulations. Carburetor
adjustments, other than idle speed, must be performed by an
authorized dealer.
◆
The cutting attachment may be moving during carburetor
adjustments.
◆
Wear your protective equipment and observe all safety
instructions.
◆
For units equipped with a clutch, be sure the cutting
attachment stops moving when the engine idles.
◆
When the unit is turned off, make sure the cutting
attachment has stopped before the unit is set down.