P
OWER
P
RUNER
TM
C
IRCLE
S
AW
A
TTACHMENT
O
PERATOR
'
S
M
ANUAL
7
• When pruning a limb 2-1/2 inch diameter cut as follows:
1. Under cut 1/4 limb diameter near tree trunk.
2. Finish top cut slightly farther out on limb.
3. Flush cut stub at trunk.
WARNING
DANGER
This product is not intended for Felling of trees or Bucking logs.
Failure to follow this recommendation can result in serious injury or
death.
MAINTENANCE
• Grease gear case with lithium based grease every 50 hours of use.
CIRCLE
SAW
BLADE
REPLACEMENT
Tools Required: 19mm (3/4”) Spanner, 14mm (9/16”) Spanner
Parts Required: Blade, P/N 43162522060
WARNING
DANGER
Failure to follow blade mounting instructions can cause blade to be
thrown from Circle Saw Attachment and result in serious injury to
the operator or nearby bystanders.
1. Remove shaft end ring (A).
2. Hold saw spacer (D), located between guard and blade, with 19mm
(3/4”) spanner. Remove flange nut (B) turning counter clockwise.
3. Lift off blade and outer saw collar (C).
4. Remove and retain shaft spacer (E) from blade center hole.
WARNING
DANGER
Failure to assemble shaft spacer in blade center hole during
reassembly, may result in uneven rotation, and possible injury to
the operator or anyone standing nearby.
5. Install new blade with shaft spacer (E) onto saw spacer (D) and inner
saw collar (C). Blade teeth should be angled toward direction of
blade rotation.
6. Install outer saw collar (C) and flange nut (B).
7. Hold blade adapter (D) from turning with spanner, and tighten nut
(B) securely with 14mm (9/16”) spanner turning clockwise.
8. Install shaft end ring (A).
A
B
C
C
D
BLADE
E
