user can be from the sound source, the 3 metre extension lead
(e)
can be connected between the M
TM
unit and the microphone. Up to 2 extension leads can be used to extend the distance between the M
TM
unit and the sound source.
Care must be taken in positioning the leads to avoid the danger of tripping etc.
4) Fully insert headset or neck loop into socket
(2)
(figure 1).
5) If using neck loop, switch hearing aid to
“T” position.
6) Set ON/OFF switch
(4)
to ON position, the LED Light
(8)
will show Green (figure 1).
7) Increase volume by gently pressing on pad
(5)
. To reduce volume press pad
(6)
.
IMPORTANT
– If the volume does not increase switch the M
TM
OFF and check that microphone and
headset or neck loop is inserted fully in the correct sockets before switching on again (figure 1).
8) To adjust tone, turn wheel (7)
Anti-clockwise for treble boost. Clockwise for bass boost (figure 1).
PLEASE NOTE
When the unit is switched on, the Power indicator light
(8)
will show GREEN if dry cells are okay.
If Power indicator shows RED when switched on, or changes to RED when in use, then the dry cells are running low
and will need to be replaced within approximately 8 hours.
If there is no Light when the unit is switched on, this normally indicates the dry cells are completely discharged and
should be replaced.
Optional Combination Audio Lead (Purchased separately)
The combination lead can be used to connect the Echo M
TM
directly to the SCART, Phono/Phono or
headphone sockets on a TV, CD, and Radio etc. instead of using a microphone.
Care must be taken in positioning
the leads to avoid the danger of tripping etc.
Technical
Specifications
Frequency response: 65Hz-6.5KHz
Physical size: 95mm x 55mm x 22mm
Maximum Gain: 45dB
Overall weight: 95gms (including dry cells)
Maximum power output: 110 dB
Dry cells: 2 x AA size (LR6)
Tone control: 10 dB range 300Hz, 10 db range 5KHz
Power supply: +3v DC
Current consumption: 30mA with 32ohm headphones and
no signal
Microphone: Electret condenser
AGC: Attack time 0.3ms, Release time 3ms
Headset Socket: 3.5mm Stereo
EC Conformity: EN 50081-1 and EN 50082-1
Hearing Products International Limited
Echo House, 26/27 Haigh Park, Stockport, SK4 1QR, England
Tel. +44 (0) 161 480 8003 Fax +44 (0) 161 480 8006
www.hear4you.com
Hearing Products International Ltd. reserve sole right to alter prices, design and/or technical specifications
or colours without prior notice. E & O.E. 17/05/07. 940-1000-03 M Instructions.
© Copyright Hearing Products International limit ed 2008
UK: Waste electrical products and batteries should not be disposed of with household waste. Separate disposal
facilities exist, for your nearest facilities see www.recycle-more.co.uk or Hearing Products International Limited for full
details www.hear4you.com
