H
EDGE
C
LIPPER
O
PERATOR
'
S
M
ANUAL
27
D
C
B
E
1.
Remove spark plug lead from the spark plug and throttle linkage
end from the carburetor swivel.
2.
Remove the four screws that retain the engine cover. Two at the
top of the starter, two on either side of the front. Lift the cover from
the engine and lay to the front of the hedge clipper.
NOTE
The throttle linkage remains assembled to the engine cover and the
spark plug lead and grommet remain installed.
3.
Use the wooden stick or brush to remove dirt from the cylinder fins.
4.
Remove grass and leaves from the grid between the recoil starter
and fuel tank.
5.
Assemble components in reverse order.
NOTE
When installing the engine cover, be certain the tab of the metal
deflector shield is in the slot of the cover.
EXHAUST
SYSTEM
Spark Arrestor Screen
Level 2.
Tools Required: Cross Head Screwdriver. Soft metal brush.
Parts Required: Screen P/N 14586240630, Gasket Lid P/N 14586642031
1.
Remove engine cover (A). See "Cleaning Cooling System" pages 26
and 27 for step by step instructions.
2.
Place piston at Top Dead Center (TDC) to prevent carbon/dirt from
entering cylinder.
3.
Remove spark arrestor screen cover (B), screen holder (C), gasket
(D) and screen (E) from muffler body.
4.
Clean carbon deposits from screen and muffler components.
5.
Replace screen if it is cracked, plugged or has holes burned
through.
6.
Assemble components in reverse order.
NOTE
When installing the engine cover, be certain the tab of the metal
deflector shield is in the slot of the cover.
Summary of Contents for HCA-2400
Page 34: ...34 NOTES...
