![background image](http://html1.mh-extra.com/html/echo/dsrm-2600/dsrm-2600_operators-manual_4035738027.webp)
25
Maintenance and care
Troubleshooting table
1. Wear
Indicators
IMPORTANT
When the wear indicators located at the bottom of the nylon
line cutting head are worn smooth, replacement of the cover or
the entire nylon line cutting head is required.
IMPORTANT
For spare parts and consumables, please use only genuine parts and designated products and components.
Using parts from other manufacturers or non-designated components may result in a malfunction.
Trouble
Cause
Remedy
Red Charger light flashes or does not
light up
1. Plug not connected to power outlet
2. Battery pack not installed properly
3. Obstructed
connection
4. Fault in the charger
5. Fault in the battery pack
1. Plug in the charger
2. Check the battery pack installation
3. Reinstall battery pack again after re-
moving obstructions from connec-
tion.
4. Consult your dealer
5. Consult your dealer
Unit will not turn on
1. Battery pack not installed properly
1. Check the battery pack installation
Unit does not run when turned on
1. Battery pack discharged
2. Line head obstructed
3. Battery pack outside acceptable
temperature range
1. Charge the battery pack
2. Turn off the unit and clean the cut-
ting attachment
3. Remove the battery pack and allow
to cool
Running time is too short
1. Battery pack outside acceptable
temperature range
2. Unit electronics too hot
3. Battery pack discharged
1. Remove the battery pack and allow
to cool
2. Turn unit off and allow to cool
3. Charge the battery pack
Line won't feed
1. Not enough line on the spool
2. Line tangled in the spool
1. Rewind with new line
2. Unwind and rewind the line
Line fails to cut off
1. Cut off knife in the shield is damaged
or missing
1. Consult your dealer
Consult your dealer in the event of a problem that is not covered in the table above, or other such concerns.
Please contact your dealer in order to dispose of the product or its parts in compliance with national laws.
Manufacturer:
YAMABIKO CORPORATION
1-7-2 Suehirocho, Ohme, Tokyo 198-8760 JAPAN
Authorized Representative in Europe:
CERTIFICATION EXPERTS B.V.
Amerlandseweg 7, 3621 ZC Breukelen, The Netherlands
Summary of Contents for DSRM-2600
Page 2: ......
Page 32: ...30 1Notes and rear cover MEMORANDUM...
Page 33: ...31 MEMORANDUM...
Page 155: ......