20
CSG-7410
WHEN THE ENGINE IS COLD
1. Fill the fuel tank with fuel mixture. It is not permitted to fill fuel above the
shoulder level of fuel tank.
2. Press the decompression device.
3. Push primer pump until fuel is visible in primer pump.
4. Pull out choke all the way (engages the fast idle throttle latch setting).
5. Securely hold the engine cut-off saw. Pull starter grip briskly, but only 1/2
to 2/3 its full length. Pulling rope to the end may damage the starter.
6. Push in the choke the first time engine fires, and crank until engine starts
and runs. In cold weather you should keep the choke out just a little until
the engine gets very warm. But, do not operate with the choke out.
7. Squeeze and release trigger when engine runs to release the fast idle
throttle latch setting. You now have trigger control of the throttle speed.
Set saw down on level ground with wheel in the clear. Grasp front handle
with left hand, and hold down rear handle with toe of your boot. Never “drop-
start” the saw.
WARNING
Wheel will rotate when engine is started at fast idle throttle latch set-
ting. Keep cutting wheel in the clear.
IMPORTANT
Check unit for loose nuts, bolts and screws before starting.
Make sure the wheel guard is securely in place.
Always clear work area of debris before starting operation.
Always hold the unit firmly.
When pulling starting rope, use short pulls, 1/2 to 2/3 of rope length.
Do not allow the starter grip to snap back against the housing.
OPERATION
Safe Starting Techniques
Decompression device
Primer pump
Choke
Starter grip
Throttle trigger lockout
Throttle trigger
Summary of Contents for CSG-7410
Page 35: ...35 CSG 7410 NOTES ...
Page 36: ...C72715001001 C72715999999 ...