7
3 INCH CHIPPER/SHREDDER
ENGLISH
ASSEMBLY
2.2 CE COMPLIANT ASSEMBLY
2.2.1 INSTALL LEG STAND, AXLE AND
WHEELS
1. Align holes in chipper base (1) with the holes in
axle weldment (2) and the support leg (3). Secure
assembly to chipper base with two 5/16-18 x 2-1/4"
hex head bolts (4) and flange nuts.
2. Secure support leg to the base of the housing body
(5) with two 5/16-18 x 1-3/4" hex head bolts (6), and
flange nuts.
3. Complete by bolting wheels (7) to axle weldment
using two 5/8 x 3" hex head bolts (8).
4. The axle bolts turn into centerlock nuts in the ends of
the axle bar and consequently turn fairly hard. Care
must be taken not to over tighten the bolts or bearing
damage will occur. A properly tightened bolt will allow
minimal side to side movement of the wheel while
allowing the wheel to spin freely.
1
2
3
4
5
6
7
8
9
10
11
12
13
15
16
14
17
2.2.2 ATTACH SHREDDER HOPPER
HANDLE
To attach handle (9) to shredder hopper (10) install four
5/16 x 1" hex bolts (11) so the head of the bolt is located
on the inside of the hopper. Secure bolts with 5/16" flange
nuts.
2.2.3 ATTACH SHREDDER HOPPER
1. Install the shredder hopper (10) to the housing body
so the handle is located above the engine and the
opening is toward the chipper chute.
2. Install eight 5/16-18 x 3/4" carriage bolts (12) so the
head of the bolt is located on the inside of the hopper.
Fasten bolts with 5/16" flange nuts.
2.2.4 ATTACH CHIPPER CHUTE EXTENSION
(CE COMPLIANT MODELS ONLY)
1. Place the chipper chute extension (13) onto the
chute. Line up the four holes located on the bottom of
the extension and the top of the chute.
2. Install four 5/16-18 x 3/4" carriage bolts (14) so the
head of the bolt is located on the inside of the chipper
chute. Fasten bolts with 5/16" flange nuts.
2.2.5 ATTACH DISCHARGE WELDMENT
1. Place the discharge weldment (15) onto the chipper.
2. Secure the top of the discharge weldment using
one 5/16 x 10" bolt (16), two washers and one 5/16"
flange nut.
3. Secure the bottom of the discharge weldment using
two 5/16 x 3/4" hex head bolts (17) and flange nuts.
The head of the bolt should be located inside the
discharge assembly.