Console Software
The input monitor controls are a little complicated. Basically, there is
a different
set of input monitor controls for each output bus
, but
only one set is viewable and
changeable at a time
. In the example above, the only set of input monitor controls
that is viewable and changeable is the one for the output bus called “ANALOG
OUT 1-2". To see and change a different set of input monitor controls you will
need to select a different output bus (see the “Bus Select” section above).
The level meters do not change when a different output bus is selected. They
always reflect the signal level being received on the inputs. In the example 2 pages
earlier you can see that the signal level on the ANALOG OUT 1-2 meters is less
than that on the input meters. This is because the ANALOG IN 1-2 faders have
been adjusted to –19, thereby decreasing the amount of the input signal that is
being sent to analog outputs 1-2. If we were to select the ANALOG OUT 3-4 tab
the Console would appear as in the example below.
26
Console Software