10
Before you start
Before you start
Assembly
Power head shaft/lower shaft assembly
1.
Set power head/shaft assembly on a level surface.
2.
Pull locator pin (A) out, and turn anticlockwise 1/4 turn to
lockout position.
3.
Remove vinyl cap from attachment drive shaft.
4.
Carefully fit attachment drive shaft assembly into coupler (B)
to decal assembly line (C), making sure that the inner lower
drive shaft engages into the square upper drive shaft socket.
5.
Rotate locator pin (A) 1/4 turn clockwise to engage lower
shaft hole. Insure locator pin is fully engaged by twisting low-
er drive shaft. Locator pin should snap flush in coupler. Full
engagement will prevent further shaft rotation.
6.
Secure lower shaft assembly to coupler by tightening clamp-
ing knob (D).
7.
To disassemble, reverse assembly instructions.
WARNING
Read the operator's manual carefully to ensure that you assemble the product correctly.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
NOTE
Lower bearing housing and head assembly must be in line with
the engine.
