![background image](http://html1.mh-extra.com/html/echo/02001001/02001001_operators-manual_3882914016.webp)
16
A
B
C
D
STARTING
COLD
ENGINE
1.
Stop Switch - Start/Run.
Move stop switch button (A) away from the STOP position.
2.
Move throttle position lever (B) midway between idle and full
throttle positions.
3.
Close Choke - Cold Start.
Move choke (C) to "Cold Start" Position.
4.
Primer Bulb -Pump.
Pump primer bulb (C) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
IMPORTANT
Recoil starter: Use short pulls - only 1/2-2/3 of rope for starting.
Do not allow the rope to snap back in. Always hold the unit
firmly.
5.
Place the blower on a flat clear area. Firmly grasp throttle grip with
left hand and rapidly pull starter handle/rope (E) until engine fires.
6.
After engine fires, move choke lever to “Run” position and pull
starter handle/rope until engine starts and runs. Allow unit to
warm up at idle for several minutes.
NOTE
If engine does not start with choke in “Run” position after 4 pulls,
repeat instructions.
7.
After engine warm up, gradually depress throttle trigger to
increase engine RPM to operating speed.
E