INSTALLATION INSTRUCTION (OPTIONS)
BOOST PUMP
Install the boost pump with the motor up or sideways in a dry location below the water line, in
between the sea strainer and the pre-filter(s). The intake is at the center of the pump. Avoid
elbows/90 degree fittings in your plumbing. The complete pump head can be turned in case the outlet
direction is not suitable for your installation.
Be sure your electrical wiring for this pump switches off and on at the same time the magnetic clutch
switches off and on, to prevent the pump from being damaged due to dry run.
5MICRON PRE-FILTER HOUSING
Connect the filter housing with the supplied ¾” nylon nipple to the standard filter housing and
reconnect the reinforced vinyl hose. The 5micron cartridge has to be installed as the second filter in
flow direction.
5MICRON PRE FILTER HOUSING WITH LOW PRESSURE GAUGE
The optional 5micron pre filter housing with low pressure gauge has to be installed as a second filter in
flow direction.
FRESHWATER FLUSH SYSTEM
Install the active carbon filter housing at a serviceable location in between your freshwater system
pump and the pre-filter housing(s). Connect one port of the shut off valve to the provided barbed tee.
Connect the two remaining ports of the tee to the outlet of the storage/cleaning valve and to the intake
of the high-pressure pump (refer to the flow diagram). Connect the intake of the active carbon filter
housing to your boat’s pressurized water system.
Summary of Contents for Watermakers 200-BMS-1
Page 17: ......
