EN
42
EN
43
ElIMINATING PROBlEMS
In case that the appliance does not operate in the expected manner, please check the following short
tips.
Problem
Possible cause
Correction
No steam generated.
Is the plug of the mains
cord connected into the
socket properly?
Connect the mains plug properly.
The red tell-tale lamp “refill
water” is flickering?
Refill water into the tank.
Low steam output.
Is the appliance not
operating in the low
regime output?
(In the display there is
indicated the regime of low
output).
It is not any defect. If you wish to set up
high output, depress the push-button of
steam output in the regime of personal
adjustment, and set up high output.
Is the atomizer not clogged
with scale?
Clean the atomizer.
The heating of steam
does not function.
Have you switched on
the heating of water in
the regime of personal
adjustment?
In the regime of personal adjustment,
depress the push-button switching on the
heating body.
Is the appliance not
switched on for short time
only?
It is not any defect. It takes 10 – 20 minutes
approximately before hot steam is let out.
(Time necessary for heating of water by
heating body).
The difference
between the actual
humidity and the
reading of the
humidity meter is too
high.
Is the air inlet not clogged
with dust?
Clean the inlet of air. Even in a single
room, the humidity can vary in its different
sections.
Do you not operate the
appliance in places where
it could be affected by
its environment easily,
for example close to a
window?
Install the appliance in a place where the
impacts of environment are less probable.
The mist has an
unusual odour.
Do you not use old water?
Clean the appliance according to
instructions, and change water regularly.
Is the suction slot or the
atomizer not clogged with
scale?