
EN
40
EN
41
Capacity of steam with full water tank
Humidifier in the following regime:
Low output – humidification for about 60 hours
Mean output – humidification for about 30 hours
High output – humidification for about 20 hours
In the regime of heat generation of steam (high output), the appliance can humidify for about 11 hours.
After depleting the water in the tank, an acoustic signal is heard repeatedly, and the indicator
WATER
starts flickering. If you wish to go on using the humidifier, refill water according to instructions.
When removing the water tank from the base, water can drip from the bottom of the tank. After
removing the water tank from the base, wipe its bottom with a rag, in order to avoid soiling of the
floor or of the furniture.
Attention:
•
After a certain period of operation, scale will deposit in the suction slot and in the
atomizer. If you go on using the appliance in such a condition, the appliance may not
operate properly, or a breakdown can occur. Clean the suction slot and the atomizer once
or twice a week.
• Change the water in the tank every day. Pay attention to quality of water. The left-over water
should be removed from the tank after every use, in order to prevent proliferation of bacteria.
MAINTENANCE ANd ClEANING
Before cleaning, do not forget to disconnect the appliance from the electric mains and wait until the
water cools down completely; in the contrary case, you could scald yourself.
Maintenance of the outside of the appliance
For wiping the outside of the appliance, use a soft moistened rag.
Attention:
• Do not submerge the appliance in water; risk of an electric shock.
• Do not use thinners, organic solvents, benzine, spirit and other aggressive agents, agents with
abrasive effect nor brushes. You could damage the surface finish of the appliance.
Maintenance of the float
Maintenance of the atomizer
Maintenance of the float
1. Using a soft wet rag, wipe off the water deposits inside the suction slot.
For the elimination of deposits on tiny parts, you can use the enclosed brush, and afterwards, wipe
them again with a soft rag.