ECG ZS 08, Instruction Manual

Page: 30 / 76

GB
30
Cutting hair
1. Make sure before you start cutting hair that the hair is clean and dry. You will achieve the best results with
dry, not wet hair.
2. Sit the person, whose hair you are cutting so that her head is at your eye level, cover her shoulders with
a towel and style her hair using a comb.
3. Always start haircut from the back side of the head.
4. You can cut hair along or against the direction of the growth, but keep in mind that when cutting against
the direction of hair growth it will be shorter than when cut along the growth direction.
5. To let your hair longer, take a strand of hair between the fi ngers and cut the hair using the clipper.
6. Cur only a small amount of hair at a time you can return to the trimmed place later and possibly cut more.
7. Comb through hair to uncover unevenly trimmed strands.
8. You can lift the hair using comb and cut it along the comb.
9. Even the haircut using scissors.
10. You will learn over time to model a perfect desired hairstyle.
Haircut examples
Note: When using attachments (
7
,
8
) observe the hair lengths markings on the attachments.
Step 1
Put on attachment “3/6mm”. Turn on the clipper using switch
3
. Hold the clipper with blades upward. Begin
cutting from the place where hair starts growing. Go slowly with the clipper upward. Cut this way the back part
of the head around the neck and around the ears.
Step 2
Turn the clipper off and put on the attachment “9/12mm”. Turn the clipper on and continue tu cut toward the
top of the head.
Step 3 – cutting temples
Turn off the clipper and put on the attachment “3/6mm”
7
. Cut the hair on the temples. Then put on the
attachment “9–12mm”
8
and continue cutting towards the top of the head.
Step 4 – cutting the top of the head
Using attachment “9/12mm”
8
cut the hair from the top of the head towards the sides and cut against the
direction of the growth.
Step 5 – fi nal part
Remove the attachment from the clipper (
7
or
8
), turn the clipper toward the hair and carefully trim the hair
on the temples and on the neck. Do not push on the clipper with force since you could risk injury or cut in case
the open blades would come into contact with skin.
Cone-shaped cut
Put on the necessary attachment (
7
or
8
) and start cutting from the neck toward the top of the head. Cut
against the growth of the hair from the forehead to the top of the head and on the sides. To achieve a fl at cut
on the top of the head use comb: always lift a strand of the hair and trim it along the comb. Comb the hair to
uncover unevenly cut strands.
CLEANING AND MAINTENANCE
WARNING: Disconnect the hand held part from the power supply before cleaning it.
• Immediately after fi nishing using the clipper turn the switch
3
to position “0”. If you are using power
adapter
0
, disconnect it from the wall outlet and then disconnect the power cable from the connector
1
.
• Remove the attachment (
7
or
8
) and using cleaning brush clean the inside of the attachment from the
hair remnant.
• You can rinse the attachments under running water. Then dry them thoroughly.
• Clean the body of the clipper
4
using lightly wet cloth and then wipe it dry.
• Never immerse in water or other liquids the body of the clipper
4
and the adapter
0
!