GB
GB
45
Before first use
•
After transporting or storing in cold conditions, the device must be allowed to acclimate at room
temperature for at least 2 hours.
CHARGING
NOTICE!
Remember that the battery capacity becomes shorter after prolonged periods of storage. Therefore,
long term charging should be avoided and the alternating of charging and discharging cycles
should be preferred.
WARNING:
Use only the adapter delivered with the shaver for charging. Make sure before charging that the
switch is in the “0” position.
The battery life is affected by ambient temperature (if it is less than 5°C, or more than 35°C).
Charging takes about 2 hours. The shaver works without connection to electricity about 60 minutes if fully
charged.
When the battery status indicator flashes red, the battery is almost exhausted (approximately 10 minutes
remaining) and the machine needs to be recharged.
•
Make sure that the appliance is off (sliding switch is in position 0).
•
First, connect the adapter connector to the stand (fig. 1) and only then connect the adapter plug to the
electric outlet (fig. 2).
•
Insert the appliance into the stand. Charging indicator lights up red.
•
When the battery is charged the indicator light changes to continuous green.
•
When the appliance is charged, disconnect the stand with the adapter from the electric outlet.
TRIMMING
The trimmer can be used for wet or dry shaving or trimming on all parts of the body.
The trimmer is not designed to clip nose or ear hair and eyebrows trimming.
Use of trimming combs
The trimmer accessories include 3 trimming combs with a cut length of 3, 5 and 7 mm.
The cut length is in mm on the back of each comb.
1. Attach the comb onto the head of the device so that the teeth of the combs point in the direction in which
you will shave (fig. 3 and 3A).
When you move the device towards you, the teeth of the comb must point toward you. (Fig. 4). When you move
the device away from you, the teeth have to move away from you (fig. 5).
Slide the switch in position I to turn on the device (fig. 6).
2. Move the device against the direction of hair growth.
3. When you finish trimming, turn the slider switch to position 0 (fig. 7).
WARNING!
Always turn off the device when changing attachments.
SHAVING
For shaving, use the device without a trimming comb!
1. If it is attached, remove the trimming comb from the head of the device (fig. 8).
Note:
When removing the attachment, gently push on the overhanging part of the comb away from the body
and remove it.
2. Slide the switch in position I to turn on the device (fig. 6).
3. Move the device against the direction of hair growth.
4. When you finish trimming, turn the slider switch to position 0 (fig. 7).
