![background image](http://html1.mh-extra.com/html/ecg/zh-1321/zh-1321_instruction-manual_3892386010.webp)
10
11
BEARD TRIMMER
English
Warning:
The red LED is on even after the device is fully charged.
The operating time with a fully charged battery is about 30-35 minutes.
USING THE APPLIANCE
NOTES:
The trimmed beard must be dry.
The length of the cut may vary according
to the cutting angle.
Start with the comb attachment set to the longest cut,
and then use shorter cut lengths gradually during cutting.
Switch on the
device by sliding the switch to the ON position.
Before cutting for the first
time, turn on the trimmer by sliding the switch to the ON position and make
sure that the appliance works normally and the blades move smoothly.
Setting the cut length
For a minimum length of the cut it is possible to use the trimmer without
a comb attachment. To completely remove the comb attachment, gently push
the attachment from the back of the device with your thumb until it releases
from the lock. To adjust the cutting length on the attachment, turn the wheel
(No. 6) clockwise or counterclockwise relative to the mark on the trimmer
body. Each setting level, see column "A", corresponds to a specific cutting
length in mm, see column "B" in the table
Setting the lengths of the cut
.
Beard trimming
Make sure that the beard is clean and dry before cutting it.
Do not use
shaving gel or foam as they may damage the trimmer.
Trim your beard in the direction of the beard growth. Make sure the head is at
a right angle to the skin.
NOTE:
Always turn off the trimmer during breaks in cutting.
CLEANING AND MAINTENANCE
You can remove the head with the blades. Press the head release button in
the direction of the arrow on the button and carefully remove the blades. The
shaving blades are sharp, so take extra care when handling them. When re-
inserting the cutting blades make sure that the head is properly seated in the
device. It has to snap into the body.
Turn off the device.
Remove the removable comb attachment and rinse
with water. Before reassembly, allow it to dry thoroughly.
Use the included
cleaning brush to clean the cutting head with the blades.
Never clean the
blade head with water or any other liquid.
We recommend gently lubricating
the moving teeth of the cutting edges with silicone oil after each use.
You
can use the supplied oil.
Use only acid free oil.
DO NOT USE
vegetable
oils, fats or oils with solvents for lubrication. The solvents evaporate, leaving
a thick layer of lubricant, which can slow down the movement of the blades.
Gently press the blades from the underside to open the head and lubricate
the moving parts of the mechanism.
Remove excess lubricant with a dry,
lint-free cloth.