ECG XMS 333 U, Instruction Manual

Page: 43 / 120

GB
42 43
42 43
AUX input
You can connect to the device an external audio output device such as an MP3 player, and listen to the sound
through the speakers of this device.
• To connect an external device to the AUX connector of this device, use a standard audio cable with 3.5mm
connectors (not supplied).
• Turn on the device and press FUNCTION to select AUX (“LINE”) mode.
• Turn on the external device (e. g. MP3 player).
• Start playback on the external player and set the required volume level on the main unit.
• When you finish playback from an external device, do not forget to turn off the device.
TROUBLESHOOTING
Before bringing the device to the repair centre, please check the following table.
Symptom Cause Correction
No power • The power supply is not properly connected to
the socket.
• Check the proper connection of the power supply.
Sound
No sound.
• The volume is set to minimum.
• The sound is muted.
• Increase the volume.
• Press PLAY/PAUSE .
Cannot play disk • The disk is inserted improperly.
• The disk is not compatible with this device.
• The disk is dirty.
• Make sure the disk is inserted with the label facing
upward.
• Clean the disk
After connecting
a USB device,
the device stops
working
• The connected USB device most likely is not
a certified type.
• The device does not play uncertified USB devices.
In case the player stops working, turn it off, unplug
the power cord from the socket and remove the USB
device. Plug the power cord back in. The device should
work normally.
The buttons on the
device do not work
• The device is experiencing interference caused
by static electricity etc.
• Turn the device off and unplug from the socket. Plug
the power cord back in and turn on the device.
The remote
controller does not
work
• The batteries are empty.
• The remote controller is not directed at the
remote controller sensor.
• The remote controller is outside of its operating
range.
• Replace the batteries with a new set.
• Make sure the remote controller is directed at the
remote controller sensor.
• Make sure the remote controller is close enough to
the device.
TECHNICAL SPECIFICATIONS
Tuner FM band range 88 ~ 108 MHz
Number of FM station pre-sets 20
CD Frequency characteristic 10 Hz ~ 20 kHz
S/N ratio (filter A) 60 dB
Dynamic range 85 dB
Distortion and noise 15 % (Max. power)
Fluctuation Jitter under 30 ns
Supported CD files CD / CD-R / CD-RW / MP3 CD
INPUTS USB USB 2.0 or USB1.1, 500 mA
Supported USB files FAT12, FAT16, FAT32
Maximum size of USB device 64 GB
AUX-IN 3.5 mm jack
XMS 333 U_manual_cz_sk_pl_hu_de_gb_hr_si_sr_fr_it_es_et_lt_lv.indb 43 17.07.2016 16:10:31