ECG VP BS6120 Animal, Instruction Manual

Page: 5 / 84

English English
5
Carpets ATTENTION
Dust collection system release button
USING THE VACUUM CLEANER
Assembly
The vacuum cleaner must be switched off and disconnected from power
before you start to assemble it!
• Insert the vacuum cleaner hose (5) into the opening on the vacuum
cleaner (11) so that the catches on the hose end snap into the opening of
the vacuum cleaner [Fig.
A
].
• Connect the telescopic tube (3) to the hose handle (1).
• If you want to adjust the length of the telescopic tube, press the loc (3A)
and adjust the length of the tube (Fig.
B
].
• Insert a brush or a nozzle suitable for the surface you want to vacuum on the other
end of the tube (3).
Vacuuming
1. Pulling out the cable: The cord has a yellow and red mark at the end. Grasp the plug and
pull the cord up to the yellow marker.
Never pull the cord past the red mark,
it could
be damaged! If you want to rewind the cord, press the retractor button (15), the power
cord will wind back into the vacuum cleaner.
2. Starting the vacuum cleaner: Insert the plug into an electrical outlet, whose parameters
correspond to the data on the type plate of the vacuum cleaner and start the vacuum
cleaner by pressing the on / off button (8). You can regulate the power using the control (7).
3. After vacuuming: Press the on / off button (8), slide it to off and unplug the power cord (14).
Press the retractor button (15) to rewind the cord into the vacuum cleaner. While winding
the cable, hold the plug of the power cord to avoid damaging it [Fig.
D
].
Power regulation
Minimal:
drapes, thin and fine fabrics.
Medium: cleaning standard surfaces, sofas, armchairs, upholstered chairs, carpets.
Maximum :
vacuuming hard floors.
•
Note:
You can also adjust the suction power using the manual air flow regulator (2)
located on the hose handle (1) [Fig.
E
]. Open the regulator to reduce the suction power.
Issues
Do not use an appliance showing any signs of damage. A damaged power cord has to be replaced in an
authorized service centre. Only this way can you prevent safety risks.
See the troubleshooting guide if your vacuum cleaner does not operate correctly. Refer to an authorized
service centre if you are not able to resolve an issue yourself. The vacuum cleaner is equipped with a thermal
motor fuse, activated in case of overheating (caused by clogging of the suction opening, filters, etc.). In this
case, switch off the appliance by pressing the on / off button and let it cool down completely for a few hours.
Before using it again check for clogged filters or suction opening.
After use
Switch off the vacuum cleaner and unplug it from the electrical outlet. Before attaching any accessories or
before cleaning the appliance, always switch off the vacuum cleaner and unplug the power cord from the
outlet.
A
3B
2
1
3A
2
1
B
4A
4
4A
4
C
8
15
D
22
E