GB
71
INSTALLATION OF THE TURNTABLE TRAY
1. Do not lay the turntable face down. The turntable must always rotate freely.
2. Do not use the oven without the turning ring and the glass tray.
3. All foods and dishes with food must be always placed on the glass tray.
4. If the glass tray breaks or the turning ring is damaged, contact your nearest
authorized service center.
INSTALLATION
Remove all packaging material and all accessories.
Check if the oven is not damaged (dented or damaged door, etc.). Do not install the microwave oven if damaged.
Kitchen worktop
Oven body:
Remove all the protective foil from the surface of the oven.
Do not remove the rectangular cover that is attached inside the
oven. This cover protects the magnetron of the oven.
Installation
1.
Place the oven on a flat surface with a sufficient amount of space
around the appliance to ensure the proper function of exhaust
vents.
There must be a minimum distance of 10 cm between the back of
the oven and the wall. There must be at least 5 cm of free space on
the sides.
a) Leave at east 20 cm of free space above the oven.
b) Do not remove oven legs.
c) Do not block exhaust vents. The oven might be damaged.
d) Place the oven as far as possible from any radio and television.
A microwave oven may cause interference to TV and radio TV signals.
2.
Connect the oven to a standard electricity network. Make sure that the voltage and frequency listed on the label on the oven match the
voltage and frequency frequency in the power network.
WARNING:
Do not install the oven above the cooking hob, near it or near other heating equipment. Placing the oven
near a heating device can result in damage to the oven and voiding of the warranty. The microwave oven is designed
for use in an open space and must not be placed in the cabinet.
The surface of the microwave oven can become hot during operation.
OVEN FUNCTIONS
Operating instructions
This microwave oven uses modern electronic controls to set cooking parameters to better suit your requirements.
If you press during cooking the button
Stop/Cancel
(Stop/Cancel), the program is interrupted, to resume press the button
Start/+30SEC
(Start/Quick start). When you press again the button Stop/Cancel the program is cancelled. When the cooking is completed, a beep sounds
and END will appear on the display. To remove it, open the door or press the Stop/Cancel button.
1. Setting the time
Once you plug the microwave oven in the outlet, the display shows
, "1:01" and a beep sounds.
Press the button
Clock/Preset
(Clock/Preset) to set the time. Press repeatedly to select 24-hour mode (Hr 24) or 12-hour mode (Hr 12).
Hub (bottom side)
Turntable
Support axis
Assembled support
Opening
20 cm
10 cm
5 cm
Hot surface!
Summary of Contents for MTD 2071 SE
Page 2: ......
