GB
20
DESCRIPTION OF THE APPLIANCE
Main components [A]
1. Control panel mask
2. Top cover
3. Slats directing the airfl ow
4. Back cover
5. Front cover
6. All directional wheels
7. Exhaust hose assembly
8. Sealing assembly for window
9. Remote control
10. Back cover
11. Place for EVA fi lter
12. Holder for winding power cord
13. Handle
14. Warm air exhaust
15. Drain for condensation water
16. CON fi lter
17. Air intake grill
18. Drain plug
19. Power cord
20. Power cord plug
Remote control [B]
1.
TIMER:
Press the timer setting button.
2.
UP:
Press this button to raise the temperature or the set time
3.
POWER:
Press this button to turn the air conditioner on and off .
4.
FAN:
Press to select high, medium or low air fl ow speed.
5.
DOWN:
Press button to lower the temperature or the set time.
6.
MODE:
Press the button to switch between cooling, air fl ow and dehumidifying.
7.
°C<->°F:
Press button to switch between Fahrenheit and Celsius scale.
8.
SWING:
This button controls the slats for direction of air fl ow.
9.
Display
Front panel [C]
1. Timer button
2. Fan speed button
3. UP button
4. Display
5. DOWN button
6. Mode selection button
7. On/Off switch
8. Remote control sensor
Note:
The buttons on the device have the same function as the remote control buttons. The display of the
temperature scale on the device can be switched by pressing buttons
v
and
V
simultaneously.
PLACEMENT AND INSTALLATION
Attention:
•
Allow the air conditioning unit stand for at least 2 hours in upright position. You can
move the air conditioner easily around the room. When moving the air conditioner
make sure that the unit is in an upright position and place it on an even surface.
Do not place and use the air conditioner in the bathroom or in humid locations.
Installing the device
Place the appliance on a level fl oor near a window.
There should be at least
50 cm
of free space around the appliance to ensure good air
circulation and to achieve optimum performance.
Installation and assembly
1. Install the exhaust hose as shown in the picture
A
lower. Screw the round connector of the exhaust hose
to the output port of hot air on the back of the air conditioner.
2. Install the sealing strip assembly in the window.
3. Open the window partially and install the sealing strip in the window as indicated in the pictures
B
and
C
. The assembly may be installed vertically or horizontally. Spread the individual parts of the assembly so
that both ends of the strip are in contact with the window frame and secure the assembly in this position.
MK 123_manual_cz_sk_en_hr.indb 20
18.2.2016 10:13:02
