![background image](http://html1.mh-extra.com/html/ecg/heat-blackline-etf-80/heat-blackline-etf-80_instruction-manual_3888819008.webp)
English
English
8
It is the customer's responsibility to prepare the location for the dryer, as well as the electrical installation and
wastewater installation. Check that the dryer is not damaged before installation. Do not install the dryer if it is
damaged. Damaged products can endanger your health.
Install the dryer on a stable, level surface.
Use the dryer in a well-ventilated, dust-free environment.
Do not reduce the space between the dryer and the floor with materials such as carpets, boards and mats.
Do not cover the ventilation grilles located on the dryer stand.
•
After installing the dryer, leave it in the same place where it was connected. When installing the dryer,
make sure that its rear wall does not touch anything (tap, socket, etc.).
•
The operating temperature of the dryer is from +5°C to +35°C. When operating outside this temperature
range, the performance of the dryer will be negatively affected and the product will be damaged.
•
Be careful when transporting the product because it is heavy. Always use protective gloves.
•
Always install the dryer at a wall.
•
The rear of the dryer must be positioned against the wall.
•
If the dryer is placed on a stable surface, use a spirit level to check that it is fully stable. If it is not, adjust the
feet until the dryer is stable. Repeat this procedure each time the dryer is moved.
•
Do not place the dryer on the power cable.
IMPORTANT NOTE:
Do not reduce the gap between the dryer and the floor with materials such as carpets,
boards and mats, otherwise the air dryer will not receive sufficient air intake.
Do not place the dryer in rooms where there is a risk of freezing. Freezing temperatures negatively affect the
dryer‘s performance. Condensed water that freezes the pump and hose can cause damage.
Installation above the washing machine
WARNING:
You cannot place a washing machine on the dryer. Observe the following precautions when
installing the dryer above the washing machine.
WARNING:
The dryer can be only placed on washing machines that have the same or greater capacity.
In order to be able to use the dryer on the washing machine, a strengthening part must be provided between
the two products. This strengthening part has to be installed by an authorized service technician.
When the dryer is placed on a washing machine, the total weight of these products can reach nearly 150
kilograms (fully loaded). Place the appliances on a solid floor that has sufficient load capacity!
Installation table for washing machine and dryer
Dryer
(Depth)
Washing machine
37-41 cm
42-45 cm
46-49 cm
50-56 cm
57-63 cm
52.5 cm
X
56 cm
X
X
61 cm
X
X
X
64 cm
X
X
X
X
Drain connection (with optional drain hose)
In products equipped with a heat pump the water accumulates in the water tank during the drying cycle. You
must drain the accumulated water after each drying cycle. You can drain the accumulated water directly into
the drain through the drain hose that is supplied with the appliance instead of regularly pouring out the water
collected in the water tank.
Connecting the drain hose
1. Pull out and remove the hose end from the rear of the dryer. Do not use any tools to remove the hose.
2. Connect one end of the drain hose supplied with the dryer to the connection point from which you
removed the hose in the previous step.