English
English
22
PROBLEM
CAUSE
SOLUTION
The dryer cannot be opened
or the program cannot be
started. The dryer does not
activate when set.
The dryer does not need to be
plugged into the mains.
Make sure the dryer is plugged into
a power outlet.
The door may be open.
Make sure the door is closed
properly.
You may not have set the program
or pressed the Start/Pause button.
Make sure that the programme has
been set and that the dryer is not in
standby (pause) mode.
The child lock can be active.
Turn off the child lock.
The programme was
interrupted for no reason.
The door may not be closed
properly.
Make sure the door is closed
properly.
There may have been a power
outage.
Press Start/Pause to start the
program.
The water tank may be full.
Empty the water tank.
Clothes have been knocked
off, flattened or destroyed.
The programme used may not be
suitable for the type of laundry.
Check the care labels and select the
appropriate programme for the type
of laundry.
Water leaking from the door.
Wrinkles may accumulate on the
inner surfaces of the loading door
and on the door seal surfaces.
Clean the inner surfaces of the
loading door and the door seal
surfaces.
The door opens by itself.
The door may not be closed
properly.
Push the door until you hear it close.
The water tank warning
symbol lights/flashes.
The water tank may be full.
Empty the water tank.
The drain hose may be bent.
If the product is connected directly
to a water outlet, check the water
drain hose.
The condenser cleaning
warning symbol lights up.
The capacitor may be unclean.
Clean the capacitor.
The filter cleaning warning
symbol lights up.
The lint filter may not be clean.
Clean the filter.
The filter seat may be clogged with
lint.
Clean the filter seat.
There may be a layer on the
surface of the lint filter that causes
obstructions.
Wash the filter with lukewarm water.
The program cannot be
started and the filter warning
light flashes
The filter seat may be clogged with
lint.
Clean the filter seat.
There may be a layer on the
surface of the lint filter that causes
obstructions.
Wash the filter with lukewarm water.
The capacitor must not be placed.
Replace the capacitor.
The program cannot be
started and the capacitor and
filter warning light flashes
The condenser and filter must not
be placed.
Replace the filter and capacitor.
The filter and capacitor warning
lights flash even when the filter and
capacitor are in place.
Contact customer service.
