![background image](http://html1.mh-extra.com/html/ecg/edf-4526-qwa/edf-4526-qwa_instruction-manual_3892473061.webp)
GB
61
3. Connect the power cord to a suitable power outlet, see rating plate of the appliance. Check, if the water
supply is fully open.
4. Close the door, press the power button and select the required washing cycle by pressing the program
button, see the Program table.
Note:
•
When you properly close the door you will hear a click. After completing the wash, you can turn off the
appliance by pressing the power button.
CHANGING PROGRAM
Basic condition: You can change the program during the operation only in case that the dishwasher runs for
only a short time. Otherwise, the detergent may be already consumed and water is drained. Then you need to
refi ll the detergent dispenser again (see section “Adding detergent”).
Press the power button to cancel the program and when you press this button again, you turn the dishwasher
on. Now you can select new required program (see “Starting the washing program”).
Note:
•
If you open the door during the washing cycle, the dishwasher stops, an alarm signal sounds and the
display shows error message “E1”. When you close the door the dishwasher starts running again after 10
seconds.
Six program indicators indicate by their lights the status of the dishwasher:
a) one light is on ---> a program is running
b) one light fl ashes -–> pause
Note:
•
If all the control lights start fl ashing, it means that the dishwasher is out of order. Turn off the main switch,
close the water supply and call service.
If you forget to load the dishes
Forgotten dishes can be loaded at any time until the opening of the detergent dispenser.
1. Open the door slightly and wait until the program stops.
2. Once the spray arms stop working, you can open the door.
3. Load the forgotten dishes.
4. Close the door, the dishwasher starts again after 10 seconds.
WARNING!
•
It is dangerous to open the door during operation, there is a risk of scalding by the hot water. The washing
program stops only when the digital display shows “- - - ” and a beep sounds 6 ×. Then turn off the
dishwasher using the power switch and turn off the water supply.
AFTER FINISHING PROGRAM
1. Press the switch to turn the dishwasher off .
2. Close the water supply.
3. Open the dishwasher door carefully, leave it ajar and wait a few minutes before removing the dishes. The
dishes can cool down and dry better.
Notes
•
Open the door carefully, the steam coming from the open door is hot!
•
Before removing the dishes and cutlery from the dishwasher, wait a few minutes, because shortly after
washing the dishes are hot and could easily crack.
Unloading dishes from the dishwasher
•
The interior of the dishwasher is usually moist.
• Unload
fi rst the bottom basket and then the upper one. Thus you will avoid water dripping from the upper
into the bottom basket.
Summary of Contents for EDF 4526 QWA++
