![background image](http://html.mh-extra.com/html/ecg/8592131306493/8592131306493_instruction-manual_531071040.webp)
GB
40
Mounting bases
1. Turn the radiator carefully upside down.
2. Place the bases on the radiator so that the screws located on the
bottom of the radiator fit into the bases and the pins on the base
into the holes in the radiator.
3. Carefully tighten the nuts and make sure that the radiator is
stable.
USING THE APPLIANCE
Note:
An odour or smoke may emit from the heat elements during the first use of the appliance or when
turning on after a longer period of time. This effect is normal and will go away after a short while.
Main switch and power level settings
0
= Radiator is off
I
= 750 W
II
= 1500 W
II
= 2000 W
Thermostat and temperature settings
When you turn the thermostat control
8
you can regulate the temperature.
When the ambient temperature reaches the desired temperature, slowly rotate the thermostat until
you hear “snap”. Be careful not to continue turning. The thermostat will follow this set temperature
and will continue to maintain it.
Turning off the radiator
First, set the thermostat control
8
in the “MIN” position and the power level control
6
to “0” position. Then
always unplug the power cable from the outlet.
Note:
Any handling of the appliance can be performed only if it is turned off with the main power switch and
unplugged from the outlet.
Protection against overheating
The internal heat fuse protects the radiator against overheating and switches off the appliance automatically.
In this case, the operating lamp will switch off.
If the appliance switches itself off, unplug the power cable from the socket. After cooling down (about
15 minutes), the appliance is again ready for use. Plug the power cable back into the socket.
If the situation persists, first make sure the thermostat controller is properly configured and whether the air
vents are not covered.
CLEANING AND MAINTENANCE
Always unplug the power cord from the outlet before cleaning and wait for the appliance to cool completely.
Clean the outer surface of the radiator with a damp cloth. Do not use sharp or abrasive agents to clean the
device, otherwise the surface of the radiator can become damaged.
You can store the radiator only after turning off the main switch, unplugging the it from the outlet and after it
cools completely.
RADIATOR STORAGE
If you do not plan to use the appliance for a longer period of time, it should be placed in a clean and dry
location protected against dust.