Operation
halogen lamp (with estimated useful life of around 50 hours). It offers an estimated useful
life of around 10.000 hours, avoiding the frequent replaces of lamp. Another important
feature is the cold light, which generates a minimum of heating to the resin and the tooth.
It eliminates the use of filters, because the light is emitted in the appropriate spectrum
(approximately 470nm). The light is directional, and emitted by a tip attached to the
handpiece front.
Move the handpiece into the patient's mouth and press the button to activate the light.
Position the light tip at a maximum distance of 2mm from the material to be
photopolymerized.
In case curing needs to be repeated, press the activation button again. In order to interrupt
the curing cycle, press the activation button again.
In case of a long period without use, remove the light guide tip and separate the handpiece
and the battery, putting them away under adequate conditions.
Keep the equipment out of the charger base until it indicates that need to recharge. In
this case, the equipment issue two beeps every 10 seconds.
The equipment will work even with the issue of beeps with light intensity satisfactory,
However, you should put the battery in the charger as soon as possible.
Activate and keep pressed the handpiece activation button until a long tone is heard; at
this moment, the LED will shut down; keep pressing the button. It will start a sequence of
10 tones with pauses of approximately one second between them. Each tone corresponds
to 10 seconds of the time setting. Release the activation button after getting the desired
number of tones, which will correspond to the time working.
When the equipment is inserted in the charging base, the battery indicator Led will turn on.
If the light is red, it means that the battery is being charged, if it is green means that the
battery load is complete.
Place the equipment in the base, connect the plug of the charger in the base and connect
the source to an electrical outlet.
Time load varies from 3 to 5 hours, depending on the time of life and the general state of
conservation of battery.
The indication of status and battery power is seen through the led located at base.
Led lightened in red: indicates the lowest level of battery power.
Led lightened in yellow: indicates the intermediary level of battery power.
Obs.: We recommend that the equipment must not be removed from the base under these
conditions.
Led lightened in green: indicates that the recharge process is finished.
If needs to maintain the equipment in the base after the end of the load, disconnect the
plug of the source from the base.
We recommend to remove the source from the electrical outlet when it is not been used.
the equipment emits a tone every 10 seconds of operation of the
Led.
-
Charged battery:
Charging the Battery
Time Settings
!!
5
Recharging the Battery
Battery Warning
