ENGLISH
PLEASE NOTE: THIS MODEL IS NOT RECOMMENDED, NOR HAS IT BEEN TESTED FOR ANY PERMANENT OR INDOOR INSTALLATION. THIS MODEL
IS PART OF OUR PORTABLE, OUTDOOR SERIES AND NEEDS TO BE TAKEN DOWN AND STORED IN A WARM, DRY PLACE AFTER EVERY USE.
THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE. VISIT SUPPORT.ECCOTEMP.COM FOR THE LATEST
VERSION OF THE MANUAL AND WARRANTY.
13
Support:
Support.Eccotemp.com
Shop Online:
Eccotemp.com
Store Locator:
Eccotemp.com/locator
MAINTENANCE
Be sure to turn the unit o
ff
and disconnect the water supply before performing any housekeeping tasks to this tankless
water heater. Vacuum around the tankless water heater for dust, dirt and lint on a regular basis. Clean the tankless water
heater and front panel by using a damp soft cloth with a few drops of mild detergent and gently wiping the surfaces of the
unit. Wipe any remaining moisture with a dry soft cloth.
Storage
When not in use, your portable tankless water heater should be stored away in a climate-controlled area.
WARNING: Item should not be left or stored in freezing conditions (at or below 32°F / 0°C). Internal damage
can occur.
Upon completion of use, prepare your water heater for storage:
1. Turn OFF water and gas supply and then disconnect from water heater.
2. Unscrew the drain valve (ribbed cylindrical stem next to the water input valve) to ensure draining of water.
3. Remove the screen at the end of the water inlet pipe and clean. Return screen after cleaning. (see housekeeping
section above for instructions)
4. Store tankless water heater in a climate-controlled area.
When the tankless water heater is not in use and remains connected to the LP-gas supply cylinder, the tankless water
heater and cylinder must be stored outdoors, in a well ventilated space, out of the reach of children, and must not be
operated in a building, garage or any other enclosed area.
Storage of the tankless water heater indoors is permissible only if the cylinder is disconnected and removed from the
water heater.
LP-gas cylinders must be stored outdoors, in a well-ventilated space, out of the reach of children, and must not be stored
in a building, garage or any other enclosed area.
Cleaning the Water Screen
1. Make sure the water heater is OFF.
2. Disconnect the water supply from the water heater.
3. Locate the screen at the end of the water inlet pipe and gently remove
with a screwdriver.
4. Rinse the screen in a sink or with a hose to remove any debris.
5. Return the screen by gently inserting back into the end of the water inlet
pipe.
6. Reconnect the water supply and turn ON the water heater.
7. Clean the water screen on a monthly basis.
Internal Water
Inlet Screen
Rain Cap Inspection
