Carefully remove the unit from its packaging. Examine the unit for transit damage. If damage is found, return the product to your local
dealer for warranty replacement. Do not use damaged or broken parts. Determine a mounting location with the least amount of curvature as
possible. Also, ensure there is a clear line of sight for oncoming traffic.
MOUNTING
CHANNELS
USE APPROPRIATE
BRACKET LENGTH
UPON INSTALLATION
Figure 1
Installation and Mounting:
Wiring Instructions:
CAUTION!
When drilling into any vehicle surface, make sure that the
area is free from any electrical wires, fuel lines, vehicle
upholstery, etc. that could be damaged.
Surface Mounting:
1. Insert the hex head bolts into the channel that best fits the
position that the product will be mounted and loosely assemble
the bracket onto the light as shown in Figure1.
2. Using the slots on the brackets as templates, mark the holes for
location. Drill holes in the mounting surface, matching the
holes in the bracket.
3. Secure the light in place with user supplied hardware.
IMPORTANT! This unit is a safety device and it must be connected
to its own separate, fused power point to assure its continued
operation should any other electrical accessory fail.
The ED9215 warning and worklight combinations are self flashing.
All wiring should be stranded and a minimum of 20 AWG. The
positive line must have an in-line 10 Amp slow-blow fuse for each
directional as shown in FIGURE 2. Isolate the yellow and blue wires
when not in use.
RED - POSITIVE
(WARNING)
SWITCH
(USER SUPPLIED)
IN-LINE FUSE
(USER SUPPLIED)
WHITE -
POSITIVE(WARNING)
SWITCH
(USER SUPPLIED)
YELLOW -
(SYNC)
BLUE -
MOMENTARY TO
GROUND (FLASH
PATTERN SELECT)/
POSITIVE (DIM ON
WARNING PATTERN
ONLY)
BLACK - GROUND
+ -
GREEN-POSITVE
(CENTER
WORKLIGHT)
(USER SUPPLIED)
SWITCH
Figure 2
Page 2 of 4
