Page 4 of 6
Important! Waterproof all connections whether inside or outside the vehicle by using sealant and wrapping with insulation tape. Wrap tape
tightly, overlapping by one-half widths so there are no gaps.
Wiring Instructions
Camera Wiring
This is the most commonly used method for users
who have the single camera system (one moni-
tor and one camera). Connect the monitor cable
with the DC connector. Power on the monitor with
cigarette lighter from a 12V vehicle.
Monitor Wiring
Power on the camera by connecting the Red
positive wire to 10 - 32 VDC power source, Black
to Negative / Ground source, and connecting
camera plug.
Pairing
Camera and monitor are paired before factory delivery.
When you need to add or change a camera, please follow the steps below for pairing.
Please finish pairing before installation.
1. Power-on the monitor, press V button to select a Channel(CH1, CH2, CH3, CH4).
2. Under the select channel interface, press Menu button to enter menu interface.
3.
Press ▲/+ or ▼/- and OK button to select and enter PAIRING.
4. Press OK button to start and you will have 20 seconds for pairing.
5. Video will be displayed after pairing.
WARNING!
If no picture is displayed after pairing, please retry pairing
steps and power-on again the camera. The pairing must be
completed within 20 seconds, otherwise you need to re-power the
camera for pairing.
Note:
To access menu, must be in single camera mode. No menu access in split camera mode.
Reverse light positive (+)
Reverse light positive (+)
