920-0003-00 Rev. B
Page 4 of 5
WARNING!
Halogen bulbs are extremely hot! Allow to cool completely before attempting to remove. Gloves and eye protection
should be worn when handling halogen lamps as they are pressurized and accidental breakage can result in flying
glass.
Maintenance & Troubleshooting
Do not oil or grease this unit. It is constructed with permanently lubricated bearings which do not need lubrication. Clean the
lens and base with soap and water, or a lens polish using a soft cloth.
Bulb Replacement:
1.
Remove the two (2) lens screws at either end of the base, and remove the lens.
2.
Remove and replace the bulb, ECCO P/N R5812BH.
Do Not touch the glass portion of the bulb
. Use clean
gloves, replacement bulb bag, finger cots, etc., to prevent hand oil from contaminating the bulb, causing failure.
3.
Replace the lens.
Problem
Possible Cause
Suggested Remedy
Unit does not function when
turned on
Poor ground or power connection
Fuse Blown
No power / improper power
Unit has been damaged
Check connections at the battery and the unit and repair
Check fuse, replace if necessary
Verify that 12 VDC is reaching unit
Return to ECCO
Rotator does not turn but
lamp functions
Open circuit in motor wiring of rotator
Unit has been damaged
Repair wiring
Replace rotator assembly or return to ECCO
Rotator turns but lamp does
not function
Lamp has burned out
Open circuit in lamp wiring of rotator
Unit has been damaged
Replace lamp
Check for loose connection or
damaged wires between motor and lamp assembly
(2 wires)
Return to ECCO
Trouble Shooting:
Ref. No. Description
Part No.
1
Replacement Lens
R5101LX*
2
Belt Drive Assembly (2 units required per unit)
R0003MGA
3
55 Watt Halogen Bulb (2 bulbs required per unit)
R5812BH
* Replace “X” with color A=Amber, B=Blue, C=Clear, R=Red
Replacement Parts/Accessories
