Page 2 of 6
Operation:
ON/OFF FLASH SWITCH: The 3 position rocker switch used to control the LED flash brightness/ off states.
CENTER LEFT/ SWITCH: The rocker switch to control LED from right to left.
CENTER RIGHT/ SWITCH: The rocker switch to control LED from left to right.
Note: Both CENTER switches in UP position puts unit in CENTER operation.
Mounting:
Mount the 37038AS LED light using the brackets supplied and user supplied mounting screws.
CAUTION: Check the chosen mounting location to ensure that the vehicle’s structure and material is adequate to support the
weight of your light.
ON/OFF PATTERN SELECT MODES:
DN= Turn the 2 position switch to off/Turn the 3 position switch to DOWN position.
UP= Turn the 2 position switch to on/Turn the 3 position switch to UP position.
X= Turn the 3 position switch to MIDDLE position.
※
The 3 position rocker switch in UP mode is in DIM state/ in DN mode is in BRIGHT state.
※
Touching the yellow wire to the black wire (ground) will change the flash patterns.
Switch
Position
Operation
NOTE
ON/OFF
FLASH
CENTER
LEFT
CENTER
RIGHT
X
DN
DN
OFF
OFF
DN
DN
DN
FLASH (BRIGHT)
P1
P5
P9
P13
P17
P21
P25
P29
UP
DN
DN
FLASH (DIM)
DN
UP
DN
RIGHT SWEEP(BRIGHT)
P2
P6
P10
P14
P18
P22
P26
P30
UP
UP
DN
RIGHT SWEEP(DIM)
DN
DN
UP
LEFT SWEEP(BRIGHT)
P3
P7
P11
P15
P19
P23
P27
P31
UP
DN
UP
LEFT SWEEP(DIM)
DN
UP
UP
CENTER (BRIGHT)
P4
P8
P12
P16
P20
P24
P28
P32
UP
UP
UP
CENTER (DIM)
LAMP 8
LAMP 1
LAMP 2
LAMP 3
LAMP
4
LAMP 5
LAMP 6
LAMP 7
Adjustment:
After the 37038AS light is securely installed, loosen the adjusting screws located on each end and tilt the light to the
desired angle. Then tighten the screws. Turn the LED light on and check the light from the front or rear of the vehicle,
through the window, to ensure that it is at the most desirable angle, and that the light is not impeded by any obstacles
and/or window tinting.
