Page 13 of 18
Emergency Mode Flash Pattern Selection
There are seven customizable emergency flash pattern modes available based on the wire combinations shown in TABLE 15. When using
individual switches, make sure to configure all possible switch combinations.
Level Mode Combinations
Flash Pattern Modes Function Wire Color(s)
Default Flash Pattern
Pattern
L1
BLU
Fast In-Out Quad - Rear
13
L2
ORG
Fast In-Out Quad - Front
25
L3
YEL
Cycle - Front/Rear
11
L1 + L2
BLU & ORG
Fast In-Out Quad - Front/Rear
1
L1 + L3
BLU & YEL
Cycle - Front/Rear
11
L2 + L3
ORG & YEL
Cycle - Front/Rear
11
L1 + L2 + L3
BLU, ORG & YEL
Cycle - Front/Rear
11
TABLE 15
To change a flash pattern on a single emergency level mode:
1. Power-up the Lightbar and apply +power to the level mode wire(s) you wish to change (see TABLE 15). The light bar will flash the default
pattern.
2. Momentarily touch the GRN pattern select wire to (+) power to cycle through to the next flash pattern shown on TABLE 16.
3. To reset the flash pattern to the factory default, hold the GRN pattern select wire to (+) power for ~5 seconds.