Ecco 200 Series Installation & Operating Instructions Download Page 3

Page: 3 / 4

3 of 4

Before installation, examine the Directional LEDs for transit damage. Do not use damaged or broken parts.

The mounting location should be in accordance with the specifications of the relevant state or territory school bus

regulations.

M5 Screw

M5 Nut

Gasket

Panel

Diagram 1.

TOP VIEW

80.0 [3.14]

8.0 [3.85]

X4 Ø 5.0mm

MOUNTING HOLES

Ø 8.0mm

Diagram 2.

NOT TO SCALE

80mm

98mm

To mount the lamp, drill four M5 clearance holes in the required position in the vehicle, to match the four fixing holes on the 200

Series LED School Bus Light. A further hole will be required to allow the cable to enter the vehicle (See diagrams 1 & 2 for

measurements). Fit the 200 Series LED School Bus Light using the four M5 screws and nuts as shown in the diagram below, with

the gasket provided between the 200 Series LED School Bus Light and the vehicle. Recommended tightening torque - 1.5Nm.

Mounting

Summary of Contents for 200 Series

Page 1: ...gnal Never take the right of way for granted It is your responsibility to be sure you can proceed safely before entering an intersection driving against traffic responding at a high speed or walking o...

Page 2: ...negative momentarily to cycle through available flash patterns see flash pattern timing table for configurations This wire must be insulated once installed to prevent accidental pattern changes Synch...

Page 3: ...mm Diagram 2 NOT TO SCALE 80mm 98mm To mount the lamp drill four M5 clearance holes in the required position in the vehicle to match the four fixing holes on the 200 Series LED School Bus Light A furt...

Page 4: ...E WARRANTIES Remedies and Limitation of Liability MANUFACTURER S SOLE LIABILITY AND BUYER S EXCLUSIVE REMEDY IN CONTRACT TORT INCLUDING NEGLIGENCE OR UNDER ANY OTHER THEORY AGAINST MANUFACTURER REGARD...