580/03.05.23/V2
P a g e |
21
of 29
Ecco Stove | Foster House | 2 Redditch Road | Studley | B80 7AX | United Kingdom
T
| +44 (0) 1527 857 814
E
W
| www.eccostove.com
For all patents
–
See Addendum
Minimum distances to non-combustibles
Rear 50mm
Sides 100mm
Top 125mm
24.
GENERAL AND HEALTH AND SAFETY
a)
Safe Operation: The outside surface temperature of your Ecco Stove 580EC2 should not be
fired to over 200°C so must not be touched or burning will occur. In the event of
overheating (over 200°C) close the fire door and ash pit door and do not refuel until the
body has cooled adequately.
ai) Minimum distances to combustible materials must be maintained (see page )
Plasterboard or plaster will crack within 300mm of the top or sides and 200mm from the
rear. Minimum distance to non-combustibles is 100mm to sides and 125mm to top 75mm
behind.
b)
No structural modification must be made to the Ecco Stove 580EC2 or structural work
carried out upon it unless by authorised personnel (aesthetic changes may be made by the
manufacturer without notice).
c)
Replacements must only be of the manufacturers supply and design.
CO Alarms:-
Building regulations require that whenever a new or replacement fixed solid fuel or wood/biomass
appliance is installed in a dwelling a carbon monoxide alarm must be fitted in the same room as the
appliance. Further guidance on the installation of the carbon monoxide alarm is available in BS EN
50292:2002 and from the alarm manufacturer’s instructions. Provision of an alarm must not be
considered a substitute for either installing the appliance correctly or ensuring regular servicing and
maintenance of the appliance and chimney system.
Periods of Prolonged Non-Use
If the stove is to be left unused for a prolonged period of time then it should be given a thorough
clean to remove ash and unburned fuel residues. To enable a good flow of air through the appliance
to reduce condensation and subsequent damage, leave the air controls fully open.
Recycling
To dispose of the stove after the product life has expired, please observe the following information:
•
Dispose of the items correctly i.e. separate the parts to be disposed of in material groups.
