Chengdu Ebyte Electronic Technology Co.,Ltd.
E106-xxxTxxS User Manual
Copyright ©2012–2023
，
Chengdu Ebyte Electronic Technology Co.,Ltd.
21
transmission mode, the first
frame data from the receiver
can be output after 3ms.
* Only distance priority is
supported at 230,400 baud
rates.
1
0
transmitting power
* Power and current are a
non-linear relationship, when
the maximum power, the power
supply efficiency is the highest;
* Current will not decrease with
power.
0
0
20 / 30 dBm (by default)
0
1
17/27d B m
1
0
14/24d B m
1
1
11/21d B m
05H
Read /
write
REG2
Channel Control (CH)
0 – 62 represent a total of 62 channels,
respectively
* Actual frequency = 410 MHz +
CH * 0.5 MHz, default 433
MHz = [0x2E].
* Range of values: 410 MHz ~
441 MHz, [0x00] ~ [0x3E].
06H
Read /
write
REG3
7
Receive the data package RSSI
* Only for general transmission
mode;
* When enabled, the module
receives the wireless data,
output through the serial TXD,
will follow an RSSI strength
byte to indicate the signal
strength when receiving the
data;
* Conversion formula: dBm =
RSSI / 2-154.
0
Close (default)
1
open
6
transmission mode
* Only for general transmission
mode;
* During the fixed-point
transmission, the module will
identify the first three bytes of
the serial port data as: high
a low a
channel, and take it as the
wireless transmission target.
0
Transparent transfer (by default)
1
Fixed-point transmission
5
Relay function
* Only for general transmission
mode;
* When the relay function is
enabled, if the target address is
not the module itself, the
module will start a forwarding;
* To prevent data return, it is
recommended to work with
fixed mode; namely, the target
address and source address are
different.
0
Close (default)
1
open
4
3
2
1
0
continue to have
07H
write
CRYPT
_H
Key High Bytes (default 0)
* Write only, read back to 0; for
encryption to avoid airborne
wireless data intercepted by
similar modules;
* These two bytes will be used as
the calculation factor to encrypt
the airborne wireless signal.
08H
write
CRYPT
_L
Key Low Bytes (default 0)
